Table of Contents
Advertisement
2-10. Main P.C. Board (0-T100)
1) 3 lands on 0-Q200
2) TY-CNL-D1.4x4.0 (I400)
3） Peel off 0-T100 where is fixed on the penta-mirror from DT as shown in Fig.38.
[Note of Assembly]
When installing 0-T100, stick 0-T100 on the Main body with care taken to the
position indicated by arrow in Fig.39 and 40.
4）Right side
-1. Unfold 0-T100 as shown in Fig.41.
-2. 2 black lead wires (A34, A37)
-3. 2 lead wires (N300)
-4. BT (10x30)
-5. Remove N300, while lifting up 0-T100 as shown in Fig.43.
N300
N304
-6. 7 lands on DX contact and A36
-7. Peel off 0-T100 from DT (5x7)
[Note of Assembly] Assembly procedures of N300
1. Cut off 2 terminals of N300 to 7 ~ 10mm.
2. Bent the terminals squarely while holding root of them.
3. Solder 2 lead wires (Red and Black: 50mm) to either
terminal.
4. Stick on N304 to periphery of N300.
Fig.39
Fig.38
Fig.41
Fig.43
27830 -9/40-
Fig.36
T94
3mm
BT(10x30)
A34
(N300) Red
Fig.42
DT(5x7)
6 lands
(DX)
Land
(A36)
Fig.37
Fig.40
DT(7x3)
Black
A37
Fig.44
Advertisement
Table of Contents
