Master/Slave Mode - Chauvet DJ Intimidator SPOT 155 User Manual

Master/Slave
Mode
Page 14 of 18
The Master/Slave mode allows a single Intimidator Spot 155 (the master) to control the
actions of one or more Intimidator Spot 155 products (the slaves) without the need of a
DMX controller. The master will be set to operate in either Automatic or Sound-Active
mode, while the slaves will be set to operate in Slave mode. Once set and connected,
the slaves will operate in unison with the master.
Configure the products as indicated below.
Slaves:
1. Press <MENU> repeatedly until SLAV, NASL, NAFA, or NStS shows on the
display.
2. Use <UP> or <DOWN> to select SLAV.
3. Press <ENTER>.
4. Connect the DMX input of the first slave product to the DMX output of the master.
5. Connect the DMX input of the subsequent slaves to the DMX output of the previous
slave.
6. Finish setting and connecting all the slaves.
Master:
1. Set the master to operate in either Automatic or Sound-Active mode.
2. Make the master the first product in the DMX daisy chain.
·
Configure all the slaves before connecting the master to the DMX daisy chain.
·
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the
master.
·
Do not connect more than 31 slave units to the master.
Intimidator Spot 155 User Manual Rev. 1