Programming The Internal Flash Memory; Asynchronous Mode - Fujitsu MB96300 User Manual

5 Programming the internal Flash memory

All Flash devices have an internal bootloader for asynchronous- as well as for synchronous-
Flash-programming:
< Asynchronous serial Flash programming via X5 or X9 (UART0 or UART2)
< Synchronous serial Flash programming via X4 (UART3)

5.1 Asynchronous Mode

This chapter describes the serial asynchronous programming of the internal Flash memory
using 'Flash Memory Programmer 16FX' in automatic mode.
For serial asynchronous programming SUB-D9 connectors X5 or X9, which are connected to
UART0 and UART2 respectively, can be used on the starter kit.
The following jumper settings are necessary:
5.1.1 Uart0
Programming
Jumper
JP21
UART0
(SIN0)
JP25
UART0
(SOT0)
JP27
UART0
(RS232/LIN)
JP28
UART0
(Vbat)
Table 5-1: Jumper Settings for Programming via UART 0 (X5)
5.1.2 Uart2
Programming
Jumper
JP37
UART2
(SIN2)
JP39
UART2
(SOT2)
JP40
UART2
(RS232/LIN)
JP42
UART2
(Vbat)
Table 5-2: Jumper Settings for Programming via UART 2 (X9)
© Fujitsu Microelectronics Europe GmbH
SK-96370-144PMC-GDC User Guide
Chapter 5 Programming the internal Flash memory
Setting Description
UART
1-2
1-2
1-2
Open
Setting Description
UART
1-2
1-2
1-2
Open
SIN0 is connected to RxD of X5
SOT0 is connected to TxD of X5
RS232 transceiver is selected for X5
X5-1 is disconnected from the power supply
SIN2 is connected to RxD of X9
SOT2 is connected to TxD of X9
RS232 transceiver is selected for X9
X9-1 is disconnected from the power supply
- 29 - FMEMCU-UG-960014-10