Beko WMB 61231CSPTM User Manual page 33

If the filter cap is one piece, pull the cap from both sides at
the top to open.
C
You can remove the filter cover by slightly pushing
downwards with a thin plastic tipped tool, through the
gap above the filter cover. Do not use metal tipped
tools to remove the cover.
Some of our products have emergency draining hose and
some does not have. Follow the steps below to discharge
the water.
Discharging the water when the product has an emergency
draining hose:
Pull the emergency draining hose out from its seat Place a
large container at the end of the hose. Drain the water into
the container by pulling out the plug at the end of the hose.
When the container is full, block the inlet of the hose by
replacing the plug. After the container is emptied, repeat
the above procedure to drain the water in the machine
completely. When draining of water is finished, close the
end by the plug again and fix the hose in its place. Turn the
pump filter to take it out.
Discharging the water when the product does not have an
emergency draining hose:
Place a large container in front of the filter to catch water
from the filter. Loosen pump filter (anticlockwise) until
water starts to flow. Fill the flowing water into the container
you have placed in front of the filter. Always keep a piece
of cloth handy to absorb any spilled water. When the water
inside the machine is finished, take out the filter completely
by turning it. Clean any residues inside the filter as well as
fibers, if any, around the pump impeller region. Install the
filter.
A
If your product has a water jet feature, be sure to fit
the filter into its housing in the pump. Never force the
filter while installing it into its housing. Seat the filter
into its place completely. Otherwise, water may leak
from the filter cap.
If the filter cap is composed of two pieces, close the filter
cap by pressing on the tab. If it is one piece, seat the tabs
in the lower part into their places first, and then press the
upper part to close.
33
EN