Beko WMB 61231CSPTM User Manual page 22

• To prevent flowing of dirty water back into the
machine and to allow for easy discharge, do not
immerse the hose end into the dirty water or drive it
in the drain more than 15 cm. If it is too long, cut it
short.
• The end of the hose should not be bent, it should not
be stepped on and the hose must not be pinched
between the drain and the machine.
• If the length of the hose is too short, use it by adding
an original extension hose. Length of the hose may
not be longer than 3.2 m. To avoid water leak failures,
the connection between the extension hose and the
drain hose of the product must be fitted well with an
appropriate clamp as not to come off and leak.
Adjusting the feet
A
In order to ensure that the product operates more
silent and vibration-free, it must stand level and
balanced on its feet. Balance the machine by
adjusting the feet. Otherwise, the product may move
from its place and cause crushing and vibration
problems.
1. Loosen the lock nuts on the feet by hand.
2. Adjust the feet until the product stands level and
balanced.
3. Tighten all lock nuts again by hand.
A
Do not use any tools to loosen the lock nuts.
Otherwise, they will get damaged.
Electrical connection
Connect the product to a grounded outlet protected
by a fuse complying with the values in the "Technical
specifications" table. Our company shall not be liable for
any damages that will arise when the product is used
without grounding in accordance with the local regulations.
• Connection must comply with national regulations.
• Power cable plug must be within easy reach after
installation.
• The voltage and allowed fuse or breaker protection
are specified in the "Technical specifications" section.
If the current value of the fuse or breaker in the house
is less than 16 Amps, have a qualified electrician
install a 16 Amp fuse.
• The specified voltage must be equal to your mains
voltage.
• Do not make connections via extension cables or
multi-plugs.
B
Damaged power cables must be replaced by the
Authorized Service Agents.
First use
Before starting to use the product, make sure that
all preparations are made in accordance with the
instructions in sections "Important safety instructions" and
"Installation".
To prepare the product for washing laundry, perform first
operation in Drum Cleaning programme. If your machine
is not featured with Drum Cleaning programme, use
Cottons-90 programme and select Additional Water or
Extra Rinse auxiliary functions as well. Before starting the
programme, put max. 100 g of powder anti-limescale into
the main wash detergent compartment (compartment nr.
II). If the anti-limescale is in tablet form, put only one tablet
into compartment nr. II. Dry the inside of the bellow with a
clean piece of cloth after the programme has come to an
end.
C
Use an anti-limescale suitable for the washing
machines.
C
Some water might have remained in the product due
to the quality control processes in the production. It is
not harmful for the product.
Disposing of packaging material
Packaging materials are dangerous to children. Keep
packaging materials in a safe place away from reach of the
children.
Packaging materials of the product are manufactured from
recyclable materials. Dispose of them properly and sort
in accordance with recycled waste instructions. Do not
dispose of them with normal domestic waste.
Transportation of the product
Unplug the product before transporting it. Remove water
drain and water supply connections. Drain the remaining
water in the product completely; see, "Draining remaining
water and cleaning the pump filter". Install transportation
safety bolts in the reverse order of removal procedure; see,
"Removing the transportation locks".
22
EN