Before Attempting To Remove The Battery; Swap Battery Mode; Replace The Battery - Honeywell Dolphin CT60 Series User Manual

Before Attempting to Remove the Battery

Before removing the battery, always do one of the following:
•
•

Swap Battery Mode

Swap Battery mode places the computer in a lower power state so that the battery
can be removed for a short time. This feature in not available on all models.
To activate Swap Battery mode:
1. Press and hold the Power button until the options menu appears.
2. Touch Swap Battery and follow the on-screen instructions.
3. Once you replace the battery, press the Power button.

Replace the Battery

Warning: If you have a CT60 model certified for use in hazardous
1. Depending on your model type, either power off the CT60 or place the unit in
2. Disconnect one end of the hand strap from the computer.
3. Press and hold down the small button on the battery latch, and then slide the
8
Power off the computer.
Place the unit in Swap Battery mode. Swap Battery mode places the computer in
a low power state so that the battery can be removed for a short time.
locations, read
Swap Battery mode. To learn how, see
latch toward the bottom of the computer to unlock the battery.
Important Information
Swap Battery
Dolphin CT60/CT60 XP Mobile Computer User Guide
on page 5.
Mode.