Battery Part Numbers; Charge The Battery Before Use - Honeywell ScanPal EDA52 User Manual

EDA52 computers are designed for use with battery model BAT-EDA52 or EDA52-
BAT-US manufactured for Honeywell International Inc. When ordering a
replacement battery, it is important to order by part number and not only by
model number. See
battery part number for your unit configuration.
For a list of compatible accessories, see the EDA52 Accessory Guide, available for
download from the product device pages at sps.honeywell.com. Contact your local
sales representative for replacement battery ordering information.
Caution: Improper battery replacement or incompatible device usage may

Battery Part Numbers

EDA52 Models
Battery Model Number
BAT-EDA52
EDA52-BAT-US
Caution: Read

Charge the Battery Before Use

The mobile computer ships with a partially charged battery. Charge the battery
with an EDA52 charging device for a minimum of 3.5 hours.
Note: Using the computer while charging the battery increases the time required to reach
a full charge.
About the USB Type C Connector
On EDA52 models equipped with a USB port, you can use a USB cable to charge
the mobile computer from a host device (e.g., laptop or desktop computer). The
connected host device must supply a minimum power output of 5V, 0.5A to the
mobile computer.
Note: If the mobile computer is drawing more current than supplied by the charging source,
charging will not take place.
EDA52 User Guide
Battery Part Numbers
result in risk of burns, fire, explosion, or other hazard. Dispose of
lithium-ion batteries according to local regulations. Risk of fire and
burns if improperly handled. Do not open, crush, heat above 60°C
(140°F), or incinerate.
Enable Airplane Mode
on the battery, charging peripheral, and device using the battery
before attempting to install, use, or charge the battery.
on page 5 for guidance on the correct
Battery Part Number
50172021-001
50183310-001
on page 12 and all cautionary markings
5