Charge The Battery Before Use; Replace The Battery - Honeywell Dolphin CN80 Series User Manual

Charge the Battery Before Use

Dolphin CN80 computers ship with a partially charged battery. Fully charge the
battery before using your computer for the first time.
Note: CN80G model battery ships separately from the mobile computer.
You can charge the battery with a Dolphin CX80 series charging accessory before
or after you install the battery in the computer. A fully discharged battery charges
in approximately 4 hours.
Note: Honeywell recommends using Honeywell accessories and power adapters. Using
non-Honeywell accessories or power adapters may cause damage not covered by the
warranty.
Warning: Ensure all components are dry prior to mating the computers
To charge the battery before you install it in the computer:
•
To charge the battery after installing it in the computer:
•
Note: Using the computer while charging the battery increases the time required to reach
a full charge.

Replace the Battery

If your battery power is low, you need to either charge the battery in the computer,
or replace it with a charged battery.
Warning: If you have a CN80 NI/CN80G model certified for use in
To replace the battery:
1. Save your files and close any open applications.
2. Press and hold the Power button until the options menu appears.
3. Tap Battery swap. Follow the on-screen instructions to place the unit in battery
Dolphin CN80 Mobile Computer
and batteries with peripheral devices. Mating wet components
may cause damage not covered by the warranty.
Insert the battery into the CX80 Quad Battery Charger or the battery well of a
Home Base or Ethernet Home Base.
Insert the computer into a CX80 Home Base, Ethernet Home Base, Charge Base,
Net Base, Snap-on Adapter, or Vehicle Power Adapter.
hazardous locations, read
7.
swap mode.
About the optional Dust Cover, page
9