Table of Contents
Advertisement
5. Place the level device on top of the grill to make
horizontal and vertical surface adjustment
6. Move the Jam Nut up to the top, do no tighten. If
the grill is unlevel, gently place a pump plier on the
swivel bottom (bearing cap) to adjust the height of
grill to level.
7. Place the grill beside cooking grill
Electrical Connection
Power cable should have been installed in the grill. If
cable replacement or new cable installation are need-
ed, please follow procedure below.
Disconnect power supply before
starting this procedure
•
All electrically operated appliances must be elec-
trically grounded in accordance with local codes;
or in the absence of local codes, with the latest
edition of National Wiring Regulations. See rating
serial plate mounted on the right side panel fo
proper voltage.
•
The entry point for the electrical connection is
located on the rear of the appliance.
•
Do not cut or remove the grounding prong from
the plug.
•
Adequate means of disconnection of the supply must be
provided.
•
It is recommended to allow enough slack on the electrical
cord to allow the appliance to be pulled out for proper
cleaning and maintenance.
1. Remove screw at back of the grill
2. Open the back panel slowly
3. Connect power cord cable into contact.
11
Advertisement
Table of Contents
