Setting The Current Time And Day Of The Week; Switching Between Am/Pm And 24 Hour Time Format - Galcon 6100 Series Installation And Operating Instructions Manual

4.1 Setting the Current Time and Day of the Week

To enable the irrigation controller to operate the irrigation system at the
correct times, the current time and day of the week must first be set.
1. Press "Enter"
"Clock" appears.
2. Press "Set" . The hour digits will blink. Set the
current hour using "Plus" or "Minus" (note the
AM and PM terms).
Another click on the arrow
minute digit to flash. Set the desired duration of
minutes using plus and minus
3. Press "Set" . A blinking arrow appears at the top of the display. Place the
arrow in front of the current day of the week using the "Plus" or "Minus" buttons.
If the most recent data item stops blinking before you finish programming it, press
"Set" to continue the programming process.

4.2 Switching Between AM/PM and 24 Hour Time Format

The default time format is the AM/PM.
There is also the 24-hour time format.
To switch between the two formats:
1. Press "Enter"
"Clock" appears.
2. Press "Set" . The hour digits blink.
3. Press "Plus"
simultaneously. The clock reading
switches from AM/PM to a 24-hour time
display or vice versa. You can switch the
time display format at any step in the programming process.
several times until the
will cause the
.
several times until the
and "Minus" buttons
11