Table of Contents
Advertisement
2. Programming the Irrigation Controller
This section describes the programming steps for a simple irrigation
schedule. It is followed by a section dealing with more advanced irrigation
controller operations.
The irrigation controller is programmed with the aid of 4 buttons:
Programming Step Selector - used to select the desired programming
mode (e.g., clock setting mode)
Parameter Selection Button - used to select the parameter to be
changed (e.g., hour, minute, etc.). The selected parameter can only be
changed when its entry is blinking on the display.
Increment Button - increases the value of the selected parameter (e.g.,
when hours is selected, from 06:00 to 07:00).
Decrement Button - decreases the value of the selected parameter
(e.g.,whenhours is selected, from 06:00 to 05:00).
2.1 Setting the Current Time and Day of the Week
To enable the irrigation controller to operate
the irrigation system at the correct times, the
current time and current day of the week
must first be set.
1. Press
several times until the
2. Press
The hour digits blink. Set the
current hour using
and PM designations).
3. Press
The minute digits blink. Set the
current minute using
4. Press
A blinking up arrow appears at
the top of the display. Move the arrow to
the current day of the week using the
or
button.
If the most recent data item stops blinking before you finish programming it,
press
to continue the programming process.
appears.
and
(Note the AM
and
.
5
Advertisement
Table of Contents
