Basic Operations – Entering Characters
Entering Characters
Follow the steps below when the character entry screen is displayed.
1
Enter characters.
≥Press 3421 to select characters and then press
until the character to enter is displayed. (Repeat this)
•
To repeatedly enter the same character, rotate
move the entry position cursor.
•
If you select an item and press
operations:
– [
]: Change the character type to [A] (upper case characters), [a] (lower
case characters), [1] (numbers), and [&] (special characters)
– [ ] ]: Enter a blank
– [Delete]: Delete a character
– [
]: Move the entry position cursor to the left
– [
]: Move the entry position cursor to the right
•
When entering a password, (A) shows the number of characters you have
entered and the number of characters you can enter.
2
Complete entering.
≥Select [Set] and then press
or
(A)
or
105
or
to the right to
, you can perform the following
.
or