Advertisement
2.
While wearing protective gloves, apply pressure to
the adapter in the counterclockwise direction while
tightening the caliper clamp bolt.
Adapter
3.
Place the spacer (TL-BR51 T=0.2mm) in the position
shown in the illustration, and then tighten the pad
adjustment screw (turn clockwise) until the rotor
touches the spacer.
Rotor
Spacer
(TL-BR51)
Pads
4.
Secure the caliper with the caliper fixing bolt.
5. Loosen the pad adjustment screw by two clicks, and
then remove the spacer.
Spacer
(TL-BR51)
2 clicks
Tightening torque:
6 - 8 N·m {53 - 69 in. lbs.}
Caliper clamp bolt
Allen key
Pad adjustment screw
5mm Allen key
Tightening torque:
6 - 8 N·m {53 - 69 in. lbs.}
6. Securing the cable
Pass the inner cable through the cable adjusting
bolt, and then tighten the cable fixing bolt.
7.
Depress the brake lever about 10 times until it
touches the grip, and check that there are no
problems with any components, and also that the
rotors and the pads do not interfere with each
other when the wheel is rotated.
8.
Turn the cable adjusting bolt to take up any slack
in the cable.
Secure the bolts with a cap as shown in the
illustration in order to prevent the bolts from
coming loose.
• BR-M475/C501
< Front >
• BR-M515/C601
39
Cable adjusting
bolt
Inner cable
Cable fixing bolt
Tightening torque:
6 - 8 N·m {53 - 69 in. lbs.}
Depress
about
10 times
< Rear >
Caps
Advertisement
