Advertisement
Wheel spoke
lacing
Recommended
tools
Usage location
Rotor installation ring
Rotor fixing bolt
Rotor tightening plate
Brake lever fixing bolt
Caliper fixing bolt
Adapter (post type) fixing bolt
Brake pad fixing shaft
Reservoir tank cover
Cable supporter
Brake hose fixing bolt
Bleed nipple
Maintenance nipple
Check that the spokes have been laced as shown in the illustration.
A radial assembly cannot be used.
Lace the spokes as shown in Figure 1 below for the left side of the front wheel (the side
where the rotor is installed), and the left and right sides of the rear wheel, and as shown in
Figure 2 below for the right side of the front wheel.
Rotating
Front left
Rear left
direction of
wheel
* For the HB-M965, the right side of the front wheel can be a radial spoke type.
XTR (M965)
TL-LR15
—
Torx wrench #25
—
Flat-tipped screwdriver
Allen key 4 mm
Allen key 5 mm
Allen key 5 mm
Allen key 5 mm
Allen key 5 mm
Allen key 5 mm
Flat-tipped screwdriver
Allen key 3 mm
Phillips screwdriver #1
Phillips screwdriver #1
Phillips screwdriver #2
Phillips screwdriver #2
Allen key 3 mm
Spanner 10 mm
Socket wrench 7 mm
Socket wrench 8 mm
—
Rear right
Front right
Fig. 1
Tool
DEORE (M555)
XT (M755)
NEXAVE (C901)
—
Torx wrench #25
Flat-tipped screwdriver
Allen key 5 mm
Allen key 5 mm
Allen key 3 mm
Phillips screwdriver #1
Phillips screwdriver #2
Allen key 3 mm
Socket wrench 6 mm
—
24
Technical Notes
Fig. 2
DEORE (M525)
—
—
Torx wrench #25
Flat-tipped screwdriver
Allen key 5 mm
Allen key 5 mm
—
Allen key 5 mm
Radio pliers
Phillips screwdriver #1
Phillips screwdriver #2
8 mm wrench
Allen key 3 mm
—
Socket wrench 8 mm
Advertisement
