Sony ILCE-9 Service Manual page 82

Preparation for Remedy
If you use the CCD cleaning Jig (New) (J-6082-663-A) below, make
sure to clean the Tip of the CCD cleaning jig below before using.
Note: Protection sheet is for preventing the scratch of a surface on the Tip
of the CCD cleaning jig.
The protection sheet may be come off the Jig when you take the Jig
from a bag, but it is no problem.
CCD Cleaning Jig (Tip)
CCD Cleaning Jig
Cleaning Procedure for Tip of CCD Cleaning Jig
1. Peel off the release paper of the tip cleaning sheet.
2. Gently press the tip of the CCD cleaning jig against the adhesive
side of the tip cleaning sheet 5 to 6 times.
* Do not slide the tip from right to left or up and down while it
is pressed down.
CCD Cleaning Jig
5. CLEANING
Protection Sheet
CCD Cleaning Jig (New)
(J-6082-663-A)
Tip Cleaning Sheet (J-6082-663-1)
Peel off the release paper
of Tip Cleaning Sheet.
Adhesive side
Cleaning Procedure for the OLPF
1. Clean up the tip of CCD cleaning jig.
2. Dab the tip of CCD cleaning jig at the OLPF, and pull up straight.
* Do not slide from right to left or up and down while dabbing.
3. Repeat "2" several times to clean up.
4. Check if there is dirt on the OLPF.
ATTENTION
If you cannot remove dirt with remedy above, cleaning by the fol-
lowing jig are used.
Soak a small amount of absolute ethanol (99.5%) (liquid cleaner)
after wrapping the CCD cleaning cloth (J-6082-636-A) around the
CCD cleaning jig (J-6082-635-A).
CCD Cleaning Cloth
(J-6082-636-A)
5-1E
OLPF
Cut
Absolute Ethanol
(99.5%)
CCD Cleaning Jig
(J-6082-635-A)
ILCE-9
SYS SET