Technical Specification - VGE Pro UV Control Monitor+ 420 Manual

Manual for:
VGE Pro UV Control Monitor+ 400/420/600 and VGE Pro UV Control Monitor+ 140/200
1

Technical specification

standby power
THD current
power factor
power loss (lamps at 3 x 250 W)
ballast efficiency, all lamps on
brownout/blackout detection
measurement inaccuracy
lamp operating current
lamp voltage
ignition voltage (closed loop controlled)
ignition duration
lamp preheat current
lamp preheat time (nominal)
lamp restart on ignition failure
duty frequency
closed loop current control
closed loop power control
ambient temperature
(to keep heat sink temperature below 80 °C (176 °F)
ballast heat sink temperature
(overheating shutdown on exceeding)
storage temperature
cooling of unit
IP protection cabinet
Altitude
operating position
lamp cable
Wiring
lamp type
output power (limited to max. value)
mains voltage
mains current (based on 10% losses)
mains power (based on 10% losses)
dimensions
weight
02/2017
5 W
30%
typical: 0.98 (min: 0.95)
typical: 5% (max. 8%)
typical: 95 % (min. 92%)
implemented, automatic lamp restart when appropriate
• duration for automatic restart: max. 500 ms
• automatic restart: 5x
typical: 3 % (max: 10%)
nominal: 2.0 A (1.3 - 2.4 A)
153 Vrms
2.9 kVpkpk / 1 kVrms
25 ms
nominal: 2.0 A (1.45 - 2.55 A)
12 s
3x
operation: 25 – 55 kHz
preheating: 25 – 50 kHz
on
off
all lamps at 250 W, mains 207 V AC: 0 °C (32 °F) - 50 °C (122 °F)
all lamps at 200 W, mains 230 V AC: 0 °C (32 °F) - 55 °C (131 °F)
80 °C (176 °F)
0 °C (32 °F) - 40 °C (104 °F)
forced cooling using integrated fan
• internal fan lagtime: 1 min
IP54
2000 m above sea level
vertical, lamp terminals at bottom
4 wire
• cable length per lamp: max. 30 m
see 'Wiring' on page 8 for details
EP2000002
Lamp VGE Pro T6 140W 867 SPT, Lamp VGE Pro T6
200W 1115 SPT
1x 140 W (max. 1x200W)
1x 200 W (max. 1x200W)
230 V AC ±10%, 45...65 hz
with 1 x 140 W, 230 V AC
with 1 x 200 W, 230 V AC
with 1 x 200 W, 207 V AC
cabinet: 400 x 300 x 150 mm (15.74 x 11.82 x 5.91
inch)
8.5 kg (18.74 lbs)
www.vgebv.nl
EP600001, EP200002
EP600001
Lamp VGE Pro T6 140W 867 SPT, Lamp VGE Pro
T6 200W 1115 SPT
3x 140 W (max. 3x250W)
3x 200 W (max 3x250W)
230 V AC ±10%, 45...65 hz
with 3 x 140 W, 230 V AC: 2.0 A
with 3 x 200 W, 230 V AC: 2.9 A
with 3 x 250 W: max. 830W
with 3 x 250 W, 207 V AC: 4.0 A
cabinet: 450 x 300 x 210 mm (17.72 x 11.82 x
8.27 inch)
base unit with mounting frame: 300 x 250 x 84
mm (11.81 x 9.84 x 3.31 inch)
10 kg (22.05 lbs)
2/18