to instructions notice attached to battery for
proper activating, charging and maintenance
procedure.
Battery Installation
The battery should be installed only when
NOTE:
properly activated and charged.
1. Install the battery in its rack.
2. Install battery holder and tighten the retaining
nut.
PARTS
Battery holder nut
3. Connect the RED (+) lead on the side of battery
as shown. Use provided screw and nut.
4. Install protective cap over terminal.
5. Connect the BLACK (–) lead on the top post.
tbl2014-007-210_a
TYPICAL
1. Battery holder
2. BLACK (-) lead
3. RED (+) lead and protective cap
Shock Absorber Installation
Shock Absorber Identification
Make sure not to mix front and rear shock ab-
sorbers at installation.
Front and rear shock absorbers can be identified
with the 4
th
digit of the spring part number.
PREDELIVERY
TORQUE
10 N•m (89 lbf•in)
tbl2013-005-001_a
TYPICAL
0 = Rear
2 = Front
Front Shock Absorber Installation
1. Safely lift front of vehicle using a hoist.
tbl2013-009-020_a
2. Remove the suspension brackets. Discard
bolts and nuts.
tbl2013-009-019_a
3. Install shock absorbers. Place reservoir, re-
bound adjuster and bolt heads outwards.
2014-1
PARTS TO BE INSTALLED
9 / 34