Front Seats; Rear Seats; Auxiliary Foam Filter Kit; Accessories Installation - BRP MAX Series Manual

tbl2014-003-002_a
1. M5 x 14 Torx screws
TIGHTENING TORQUE
M5 x 14 Torx screw
4. Adjust the length of the lateral net straps.
5. Buckle off the lateral net.

Front Seats

tbl2014-007-217_a
TYPICAL
1. Driver's seat
2. Passenger's seat
1. Insert the seat in the cockpit.
2. Install the seat support into retaining bracket.
3. Push down the backrest to latch the seat.
Seat Latch Adjustment
If the seat is hard to lock, the seat latch pin must
be readjusted.
Loosen retaining screws and reposition the seat
latch pin.
PREDELIVERY
4.5 N•m (40 lbf•in)
tbl2011-001-062

Rear Seats

tbl2014-007-209
TYPICAL
Prior to installing passenger's seat, check
NOTE:
the engine oil level. Refer to
VERIFICATION in this bulletin.
1. Insert the seat in the cockpit.
2. Install the seat support into retaining bracket.
3. Push down the backrest to latch the seat.

Auxiliary Foam Filter Kit

If vehicle is used in dusty and muddy conditions,
it is strongly recommended to install the foam fil-
ter kit in addition to the air filter. The kit is located
in glove box. For the installation, refer to the in-
struction sheet supplied with the kit.

Accessories Installation

1. Install accessories (if any) as per their installa-
tion instructions (included in each kit).
2. Install any other equipment required by law (if
any).
2014-1
PARTS TO BE INSTALLED
ENGINE OIL LEVEL
17 / 34