Set-Up; Tires Pressure; Wheel Beadlock; Protective Materials - BRP MAX Series Manual

SET-UP

Tires Pressure

From factory, tires air pressure could be different
from the recommended air pressure. To ensure
proper seating of the tire bead, inflate tires at
200 kPa (29 PSI) THEN set tire pressure to vehi-
cle specification. Refer to the following table.
NOTICE Always check pressure when tires are
cold.
NOTICE
Low pressure may cause tire to de-
flate and rotate on wheel. Overpressure may
burst the tire. Always follow recommended
pressure. Since tires are low-pressure type, a
manual pump should be used.
Tire pressure varies with temperature and
NOTE:
altitude.
TIRE PRESSURE
MINIMUM
MAXIMUM
(USE WHEN
TOTAL LOAD IS
GREATER THAN
180 KG (397 LB)

Wheel Beadlock

Wheel Beadlock Tightening
X rs Model
NOTICE Do not use an impact wrench for
tightening beadlock screws in order to avoid
to damage them.
Check beadlock screws tightening as per the fol-
lowing sequence.
tbl2011-001-068_a
TYPICAL
PREDELIVERY
FRONT REAR
124 kPa 124 kPa
(18 PSI) (18 PSI)
138 kPa 179 kPa
(20 PSI) (26 PSI)
PART
Beadlock screws
Wheel Beadlock Gap Verification
X rs Model
Verify the gap between tire and beadlock clamp
ring, it should be practically equal all around the
ring.
tbl2013-009-120_a
1. Tire
2. Beadlock clamp ring edge
A. Gap equal all around bead lock clamp ring
Readjust if required. Refer to proper shop manual
for complete procedure.

Protective Materials

Ensure that all protective materials are removed
from vehicle.
Recall or Factory-directed
Modification
Complete applicable recall or factory-directed
modification.

B.U.D.S. PROGRAMMING

Diagnostic Connector Location

The diagnostic connector is located under the
dashboard on the driver's side. It is stored in its
protective cap besides the fuse box.
2014-1
B.U.D.S. PROGRAMMING
TORQUE
8 N•m (71 lbf•in)
21 / 34