Installation and Operation, cont'd
Mounting under a desktop
Under-desk mounting requires the optional MBU 149 1U, under-desk mounting kit
(part #70-222-01).
Mount an SW8/12 VGA Ars under a desktop as follows:
1.
2.
3.
4.
5.
6.
7.
Figure 2-2 — Mounting the switcher under a desktop
2-4
SW8/12 VGA Ars • Installation and Operation
Install the mounting brackets on the unit's sides with the eight machine
screws provided in the kit.
Hold the unit (with brackets attached) against the underside of the desk.
Mark each bracket's hole location on the underside of the desk.
Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot holes from the
underside of the desk at the marked hole locations.
Insert the four wood screws into the pilot holes and tighten until
approximately 1/4" (6.4 mm) of the screw's head is protruding.
Install the mounting brackets, with the unit attached, over the protruding
screw heads.
Slide the unit slightly to lock it in place.
Tighten all four screws to secure it in place.
#8 Screw
(4 Plcs)
Each Side
Optional Furniture Mounting Bracket
Mounting Screws
(2 Plcs)
Each Side