Replacing The Platen Assembly - Toshiba B-FP2D Series Maintenance Manual

2. MAJOR UNIT REPLACEMENT

2.3 Replacing the Platen Assembly

1) Continue after Section 2.1 Removing the Function Unit.
2) Loosen or remove the two screws as shown blow.
2) Slowly put down the Lower sensor assembly and lift the Platen Assembly. Careful not to damage the flex.
3) Replace the Platen Assembly with a new one, then perform reassembly in the reverse order of removal
NOTES:
1. After replacing the Platen, refer to the Setting Operation Manual or System Mode Manual and perform
the following operations.
Perform a RAM clear.
2. Perform a test print and make sure printing is even. (Refer to Section
If the printing is uneven, make sure the platen ass'y is surely fixed with the hooks.
Lower Sensor Assembly
2-4
2.5 Replacing the Logic Card
Platen Assembly
Platen Assembly
4.6 in the System Mode Manual.)
SPTM-0325