Wiring The Power Inputs - Interlogix IFS MC350-4T-2S User Manual

2.1.4 Wiring the Power Inputs

The 6-contact terminal block connector on the top panel of Industrial Gigabit Ethernet Switch is used for two DC redundant
power inputs. Please follow the steps below to insert the power wire.
1. Insert positive / negative DC power wires into the contacts 1 and 2 for POWER 1, or 5 and 6 for POWER 2.
2. Tighten the wire-clamp screws for preventing the wires from loosening.
1
Power 1
-
The wire gauge for the terminal block should be in the range between 12 and 24 AWG.
V1- V1 +
2 3 4
Fault
+
13
V2 - V2 +
5 6
Power 2
- +