Furniture Mounting - Under-Desk; Furniture Mounting - Through-Desk (Cveq 100 Only) - Extron electronics A-3 User Manual

QuarterRackStandardShelf
Installation
1U Universal Rack Shelf
Both front false faceplates
use 2 screws.
Use 2 mounting holes on
opposite corners.
Mounting the line driver on a standard rack shelf
6" Deep Rack Shelf
Front false
faceplate
uses 2
screws.
Use 2 mounting holes on
opposite corners.
Mounting the line driver on a 6-inch rack shelf
CVEQ 100 and SVEQ 100 Series • Installation
2-6
1/2 Rack Width Front False
Faceplate
1/4 Rack Width Front False
Faceplate
(2) 4-40 x 3/16"
Screws
1/2 Rack Width Front False
Faceplate
(2) 4-40 x 3/16"
Screws
QuarterRackUnderdeskMounting
Furniture mounting — under-desk
To mount the line driver under furniture, use the optional
VersaTools under-desk mounting kit for the SVEQ 100
(Extron MBU 123, part #70-212-01) or the optional under-desk
kit for the CVEQ 100 (Extron MBU 125, part #70-077-01).
Under-desk mounting kit
part # 70-212-01
Preparing the line driver for under-desk mounting
1. If rubber feet were previously attached to the bottom of the
unit, remove them.
2. Attach the mounting brackets to the line driver with the
provided machine screws as shown in the previous figure.
3. Hold the unit with the attached brackets against the
underside of the table or other furniture. On the mounting
surface, mark the location of the bracket's screw holes.
4. Drill ³⁄ ³² " (2 mm) diameter pilot holes, ¼" (6.3 mm) deep in
the mounting surface at the marked screw locations.
5. Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until slightly less
than ¼" of the screw head protrudes.
6. Align the mounting screws with the slots in the brackets
and place the unit against the surface, with the screws
through the bracket slots.
7. Slide the unit slightly forward or back, then tighten all four
screws to secure it in place.
8. Attach input and output cables. See chapter 3.
Furniture mounting — through-desk
(CVEQ 100 only)
To mount the CVEQ 100 through furniture, use the optional
VersaTools through-desk mounting kit (Extron MBD 129,
part #70-077-02), as follows.
CVEQ 100 and SVEQ 100 Series • Installation
Under-desk mounting kit
part # 70-077-01
2-7