Table of Contents
Advertisement
4.
Insert the four wood screws into the pilot holes. Fasten
each screw into the installation surface until just less than
1/4" of the screw protrudes.
Align the installed screws with the slots in the mounting
5.
brackets, and place the interface against the surface, with
the screws through the bracket slots.
6.
Slide the interface slightly forward or back, then tighten all
four screws to fasten it in place.
Through-desk mounting
1.
If rubber feet were installed on the interface, remove them.
Figure 2-4 — Through-desk mounting
RGB 201 Rxi Universal Interface • Installation and Operation
2-7
Advertisement
Table of Contents
Need help?
Do you have a question about the Universal Video Interface with Audio RGB 201 Rxi and is the answer not in the manual?
Questions and answers