Internal Configuration - Extron electronics Universal Video Interface with Audio RGB 201 Rxi User Manual

Internal Configuration

The interface is factory configured to output RGBHV or RGBS
video whose sync follows the input and that is clamped to the
back porch. The interface can be configured to output positive
or negative sync, output RsGsBs video, or to clamp on the sync
tip. All of these reconfigurations require opening the interface's
case.
1.
Figure 2-1 — Opening the interface
2.
3.
4.
RGB 201 Rxi Universal Interface • Installation and Operation
Remove the three screws on each side and the two screws
on top of the cover (figure 2-1).
L E
V E
L
P E
A K
B O
O S
T C E
N T
E R
C O IN G
N T
R O
L
Move the cover back slightly to clear the BNC connectors
and then lift it away carefully to avoid straining any cables.
Configure the interface as desired. See Sync polarity
jumpers, Internal sync DIP switches (RsGsBs), and Video
clamping jumper in this chapter. Figure 2-2 shows the
location of all of the user-serviceable components.
Replace the cover and reinstall the screws.
Slide cover back slightly,
lift straight up.
R G
B
2 0
1 R
x i
W IT
H A
D S
P
T M
Remove (8 )
Screws
2-3