Table of Contents
Advertisement
Installation and Operation, cont'd
Mounting the Interface
The interface can be mounted on tabletops, under desks,
through desks, or on racks, as described in this section.
Tabletop placement
For tabletop or desktop placement only, install the self-adhesive
rubber feet/pads (provided) onto the four corners of the bottom
of the interface enclosure.
Under-desk mounting
1.
Figure 2-3 — Under-desk mounting
2.
3.
RGB 201 Rxi Universal Interface • Installation and Operation
2-6
Secure the optional under-desk mounting brackets
(part #70-077-01) to the interface with the six machine
screws provided in the mounting kit (figure 2-3).
L E
V E
L
P E
A K
B O
O S
T
C E
N T
E R
C O
IN G
N T
R O
L
Hold the interface with attached brackets against the
underside of the desk or other furniture. Mark the location
of holes for screws on the desk.
Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot
holes in the table or desk at the marked screw locations
from the underside/inside (concealed side) of the
furniture, where the interface will be located.
R G
B 2
0 1
R x
i
W IT
H A
D S
P
T M
Advertisement
Table of Contents
