Coordinate Measurement; Entering Instrument Station Data - Kolida KTS440 Series Manual

10. COORDINATE MEASUREMENT

· After inputting instrument height and target height, it is possible to find the 3-dimensional coordinates for the
target based on station point coordinates.
· It is possible to set the azimuth angle of a backsight station by entering the coordinates of the instrument station
and a known point (backsight station) and then sighting the backsight station to be measured.
· The following preparations are needed for coordinate measurement.
Station point coordinates setting
Azimuth angle setting
· For the coordinate measurement method, see "7.4 Setting the Instrument Options".

10.1 Entering Instrument Station Data

· Before coordinate measurement, enter instrument station coordinates, the instrument height, target height.
· Use a tape to measure the instrument height and target height.
· It is possible to set coordinate data into instrument.
· It is possible to record the set instrument station data in the JOB which has been selected. For the JOB selection
method, see "20.1 JOB Selection".
· It is also possible to perform coordinate measurement when MENU on the third page of the MEAS mode is
pressed to enter Menu Mode, then "1. Coordinate" is selected.
46