E) Usb/Memory Card Operation - Renkforce RF-ARA-300 Operating Instructions Manual

Table of Contents

Advertisement

F/PS/
button(2)
• Keep this button pushed to activate automatic storage of stations. This function enables automatic assignment of
all stations with a strong signal to station buttons 1-6 (12-17).
• After this procedure, the stored stations are played for a few seconds.
• Briefly pressing this button plays all stored stations for a few seconds (same function as automatic storage of
stations).
• To permanently play the selected station, briefly press the F/PS button (2) again.
• This button is also used to operate the hands-free set (further details can be found under the "Bluetooth
of this manual).

e) USB/memory card operation

The device is equipped with a USB port and an SD memory card reader. MP3 files stored on these media cannot
the played.
Do not connect an MP3 player operated with batteries with the USB port. The power supply of the USB port
can charge the batteries and lead to overheating and even explosion of the batteries.
USB data carriers with a memory capacity of up to 64 GB and current consumption of up to 500 mA can be
connected to the USB port. The device also supports SD cards up to 64 GB. All data carriers must be
formatted in FAT 32.
Only USB data carriers can be connected to the USB port. MP3 players with a USB port automatically
switch to the PC mode when plugged into this port. This mode does not support playback of music files.
The audio output of your MP3 player can be connected to the AUX port (18).
We cannot guarantee that all USB and SD data carriers will be recognised due to their manufacturer-
specific functions and that the functionality of those recognised will not be restricted.
If the storage medium cannot be recognised, pull it out and plug it in again.
• Open the cover and connect your USB data carrier to the USB port (19).
• If you want to use an SD memory card, insert it into the SD card reader (7).
• The amplifier will automatically switch to the respective input and start playback.
• The medium that was connected last is always selected automatically.
1/
button (12)
• Push this button to interrupt the playback briefly.
• When you press the button again, playback resumes at the point where it was interrupted.
20
operation"
®

Advertisement

Table of Contents
loading

This manual is also suitable for:

2373345

Table of Contents