Operation; Safety Instructions For Operation - Siemens SIMOTICS DP Operating Instructions Manual

Operation

Observe the following when carrying out any work on the machine:
• Comply with the general safety instructions (Page 11).
• Comply with the applicable national and sector-specific regulations.
• When using the machine within the European Union, comply with the specifications laid
down in EN 50110‑1 regarding safe operation of electrical equipment.
8.1

Safety instructions for operation

Hazardous voltages at the machine
Electrical machines have hazardous voltage levels. Contact with these can result in death,
serious injury or material damage.
Operating the machine on a line supply system with a non-grounded neutral point is only
permissible for short periods of time that occur rarely, e.g. the time leading to a fault being
eliminated. Cable ground fault EN / IEC 60034-1.
Risk of injury due to rotating parts
Rotating parts are dangerous. Touch protection against rotating parts is no longer guaranteed
if covers are removed. Touching rotating parts can result in death, serious injury or material
damage.
• Carefully ensure that all of the covers are closed while operational.
• First switch off and disconnect the machine if you must remove covers. Carefully comply with
the "5 safety rules".
• Only remove the covers when the rotating parts have come to a complete standstill.
1FZ shaft height 280
Operating Instructions, 02/2022, A5E51698698A
8
85