Maintenance; Preparation And Notes; Marking - Siemens SIMOTICS DP Operating Instructions Manual

Maintenance

Through careful and regular maintenance, inspections, and overhauls you can detect faults at
an early stage and resolve them. This means that you can avoid consequential damage.
Operating conditions and characteristics can vary widely. For this reason, only general
maintenance intervals can be specified here. Maintenance intervals should therefore be
scheduled to suit the local conditions (dirt, starting frequency, load, etc.).
Observe the following when carrying out any work on the machine:
• Comply with the general safety instructions (Page 11).
• Comply with the applicable national and sector-specific regulations.
• When using the machine within the European Union, comply with the specifications laid
down in EN 50110‑1 regarding safe operation of electrical equipment.
Note
Please contact the service center, if you require support with service, maintenance or repair.
9.1

Preparation and notes

9.1.1

Marking

When making changes or repairs, maintain the corresponding design standards! These
machines are labeled on the rating plate with the following markings.
1FZ shaft height 280
Operating Instructions, 02/2022, A5E51698698A
UKCA marking
Great Britain (England, Wales and Scotland)
Underwriters Laboratories
Canadian Standard Association
9
95