Table of Contents
Advertisement
SETUP WINDOW
B.
On bottom cover of the Aura series thermal printer, there is
screwed a metal plate for setup window. In this window, there is a
8 position DIP switch for printer setup. Please use proper tool to
change the switch setting when necessary. The switch position
counting starts from the nearest edge of printer. The ON direction
points to the connector area of the printer. The OFF direction
points to the power switch. The functions of each position may
evolve with the revisions of the firmware. The information below
applies to the latest version to the date of print of this manual.
This 8 position DIP switch works as following:
Switch
position
1
RS232 baud rate definition or Parallel interface
2
3
Even parity
4
XON handshaking
5
Busy on "buffer full"
6
Immediate cut
7
CR code effective
8
Factory internal setting
Effect of positions 1 & 2 on baud rate is defined as in table
below with parity check set according to position 3, number of
data bits always set to 8, and stop bit set to 1. When the parallel
interface is used, please set both positions to ON.
SW Pos. 1 ON
SW Pos. 2 ON
Baud
rate
38400 bps /
or Interface
(Parallel)
Switch position 3 defines the parity check regulation in
serial interface. In Aura, it is selectable between even and none.
ON
definition (ref. separate table below)
OFF
ON
4800 bps
5 - 2
OFF
None parity
Hardware handshaking
Busy on "off line"
Protective cut
CR code ineffective
Application standard mode
ON
OFF
9600 bps
OFF
OFF
19200 bps
Advertisement
Table of Contents
