ATOMSTACK X7 Pro Series Installation Manual page 30

8. Start, Termination carving or cutting
1.Start:
After finishing all the above operations, click the green
button as shown in the figure to start engraving. There is a
number that can be edited next to the start button. It is the
number of times of engraving or cutting, LaserGRBL allows
multiple consecutive engraving or cutting of uniform
shapes, this function is especially useful for cutting.
Picture 1 Start
2.Termination
If you want to terminate the job midway, you
can click the terminate button as shown in the
picture to terminate the engraving or cutting.
Picture 2 Stop