aventon Aventure User Manual page 15

Step 11: Adjusting the seat position and angle
To change the angle and horizontal position of the seat:
A.Use a 5mm Allen wrench to loosen the seat adjustment bolt on the clamp positioned directly underneath the seat,
above the rear wheel. Do not completely remove the bolt.
B.Move the seat backward or forward and tilt to adjust the angle. The seat position horizontal to flat ground is desirable for
most riders. Do not exceed the limit markings on the seat rail, which show the minimum and maximum horizontal movement
allowed.
C.While holding the seat in the desired position, use a 5mm allen key to tighten the seat angle adjustment bolt securely to
the recommended torque value(8Nm).
Step 12: Adjusting the display and handlebar.
A. Stand in front of the bike and clamp front wheel between both legs, verify the handle bars are straight and
in line with the front wheel. Make sure the pinch bolts are tight and you can not turn the stem freely from
the front wheel.
Seat Adjustment Bolt
14