aventon Aventure User Manual page 13

Step 7: Pedal installation.
Use wrench to install the pedals. Locate the pedal with a smooth pedal axle exterior and an "R"
sticker label (1, below), which indicates it is the right pedal. The right pedal goes
on the crank on the right side of the bike (which has the drivetrain gears and is the same as a rider' s right
side when riding).
1. The right pedal (pedal with "R" sticker label) is threaded so that it is tightened by turning clockwise.
Apply grease to the thread and carefully thread the right pedal onto the crank on the right side of the bike
slowly and by hand. Do not cross thread or damage the threads.
2. The left pedal (pedal with "L" sticker label) is reverse-threaded and tightens counterclockwise.
Apply grease and carefully thread the pedal onto the left crank by hand slowly.
Do not cross thread or damage the threads.
Torque each pedal to 35 Nm.
Identifying marks Right pedal (has a "R" sticker) tightens clockwise, Left pedal (has a "L" sticker)
tightens counterclockwise
Grease
Step 8: Remove motor protector and install the motor protection guard on right side of back wheel.
Note: Part of plastic motor protector may break and will be left inside the freewheel.
Use a pair of pliers to carefully remove it.
Wrench
12