Nortel DMS-10 Series Quick Reference Manual page 50

40 Disk Replacement Procedure
Procedure 3
Install replacement disk drive
Step
10 380 MB, 760 MB, 1 GB and 2 GB Turbo or 1 GB Non-Turbo
Disk Format
This command is to be used when the BMC (AMAT)s response
to the DISK MODE xP (x - A or B) command is DISK NOT
FORMATTED
CAUTION
These disk commands may cause a loss of data. Make sure
the operational disk drive is in an ONLY mode before enter-
ing commands.
Enter: (at the terminal)
>DISK FORMAT x (cr)
where: x - A for newly replaced disk A
- B for newly replaced disk B.
Proper response:
DISK FORMAT STARTED
The format should take about 15-20 minutes. Proper response:
FORMAT DONE
If the response is FORMAT DONE, go to step 6. If DISK
FORMT FAILS, switch processors and repeat step 10. If the
DISK FORMAT fails on the other processor, call the next level
of support.
11 Disk Parameters for 30 to 380 MB Non-Turbo Disk Drives.
Enter: (at the terminal)
>DISK PARAM (cr)
Enter the number from the displayed list that describes the type
of the replacement disk drive.
If replacing a 30 to 380 MB Non-Turbo disk drive, go to step 7.
297-6201-500 BMCA001 and up
Description
Standard 02.01 July 1997