Nortel DMS-10 Series Quick Reference Manual page 19

Disk Commands
Command Name
DISK DEFMAP x
DISK FORMAT x
Note: Do not use the DISK FORMAT command for 380 MB Non-
Turbo disk drives.
CAUTION
The DISK FORMAT command will erase all data from
specified disk drive. Should not be done during high
traffic on Non-Turbo BMC systems with 5 1/4" disks.
DISK INIT 1x
Note: Do not use the DISK INIT command on Turbo BMCs and
Non-Turbo BMCs equipped with 3 1/2" disk drives.
DISK MODE
DISK MODE xy
CAUTION
The DISK MODE command can over write needed data.
This operation takes several minutes.
DISK PARAM
DISK RESTART
Note: The DISK RESTART command is for Turbo BMCs and Non-
Turbo BMCs equipped with 3 1/2" disk drives only.
DISK VS
DISK USAGE
Maintenance Commands 9
Explanation
Enters the defective tracks for 30-140
MB disk drives (Non-Turbo BMCs). Bad
track information comes with disks.
x - disk drive: A or B.
Formats the specified disk drive. This
operation takes several minutes.
x - A or B.
Performs a short init on a specified disk.
x - disk drive: A or B
Displays the current disk mode.
Changes current disk mode.
x - Primary disk: A or B
y - O: No standby disk on-line. OR
P: Standby disk on-line.
Displays choice of disk types used for
Non-Turbo BMCs equipped with 5 1/4"
disk drives. Enter 1-9 depending on the
disk type used.
Perform a reset on the SCSI I/F PCA.
Displays the disk firmware version.
Displays the number of tracks used / total
tracks available. Refer to Table 4.
BMC II AMAT Quick Reference Guide