Specialized AETHOS User Manual page 11

3
FIG. 3: Pull on the cable exiting the bolt hole, while guiding the backing plate up into the seat tube, until it rests against the inside of the seat tube.
„
FIG. 4: Guide the front derailleur hanger over the cable, then with the cable still pulled taut, thread the lower bolt into the backing plate.
„
If a Di2 wire will be installed, keep the lower bolt loose while still threaded into the backing plate, while keeping the cable in place, rotate the front derailleur hanger out of
position so the wiring hole is exposed, then guide the wire through the seat tube and backing plate hole until it exits the bottom bracket shell.
FIG. 5: Remove the cable by guiding it down the seat tube, then thread the upper bolt into the backing plate.
„
4
SHIFT CABLE
HEAD
5
8