Chapter 1 Important Information; Declaration Of Conformity - Raymarine REALVISION 3D Installation Instructions Manual

Stainless steel through-hull transducer
Hide thumbs Also See for REALVISION 3D:
Table of Contents

Advertisement

Chapter 1: Important information
Warning: Product installation and operation
• This product must be installed and operated in accordance with the instructions
provided. Failure to do so could result in personal injury, damage to your vessel
and/or poor product performance.
• Raymarine recommends certified installation by a Raymarine approved installer.
A certified installation qualifies for enhanced product warranty benefits. Contact
your Raymarine dealer for further details, and refer to the separate warranty
document packed with your product.
Warning: High voltage
This product contains high voltage. Do NOT remove covers or attempt to access
internal components, unless specifically instructed in the documentation provided.
Warning: Positive ground systems
Do not connect this unit to a system which has positive grounding.
Warning: Switch off power supply
Ensure the vessel's power supply is switched OFF before starting to install this
product. Do NOT connect or disconnect equipment with the power switched
on, unless instructed in this document.
Warning: Transducer operation
Only test and operate the transducer in the water. Do NOT operate out of water
as overheating may occur.
Warning: 2 person installation required
To prevent potential product damage, vessel damage and personal injury
2-person installation is recommended.
Warning: Marine-grade sealant
Only use marine-grade neutral cure polyurethane sealants. Do NOT use sealants
containing acetate or silicone, which can cause damage to plastic parts.
Caution: Service and maintenance
This product contains no user serviceable components. Please refer all
maintenance and repair to authorized Raymarine dealers. Unauthorized repair
may affect your warranty.

Declaration of Conformity

FLIR Belgium BVBA declares that the following products are in compliance with the EMC Directive
2014/30/EU:
• RV-400 Stainless steel thru-hull transducer, part number A80615
• RV-412P Stainless steel thru-hull transducer, part number A80616
• RV-412S Stainless steel thru-hull transducer, part number A80617
• RV-420P Stainless steel thru-hull transducer, part number A80618
• RV-420S Stainless steel thru-hull transducer, part number A80619
The original Declaration of Conformity certificate may be viewed on the relevant product page at
www.raymarine.com/manuals.
Important information
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rv-400Rv-412Rv-412pRv-412sRv-420Rv-420p ... Show all

Table of Contents