Installation Of Dsc Jig Driver; Adjustment Softwareinitiation Method - FujiFilm FinePix F30 Service Manual

FinePix F30 Service Manual

4-5-2. Installation of DSC jig driver

* Since this camera uses the USB for communications with
the personal computer, in order to start the PC adjustment
software, [the DSC jig driver] needs to be installed in the
personal computer beforehand.
* The DSC jig driver is the same as that for the FinePix
S7000, so if this jig driver software is already installed in the
personal computer, it is not necessary to install it.
The procedure is given below.
<Step 1>
DSC jig driver (ZJ00684-100.ZIP) is downloaded from Web
server (http://fujifilm-di.intranets.com/).
<Step 2>
Defrost the downloaded compression software
<Step 3>
Double-click setup.exe in the folder of defrosted ZJ00684-
100 and install Fuji FILM DSC Jig Driver as follows.
<Step 4>
Install the software in [C:\ProgramFiles\Fjig] according to the
instructions on the PC's screen.

4-5-3. Adjustment softwareinitiation method

When the folder has been copied to the C drive, double-click
on the file C:\FinePixF30_W\ffw.exe (Fig.4-5-5) to start the
adjustment software.
4. Adjustments
<Fig. 4-5-4>
<Fig. 4-5-5>
51