Configuring Routing Between An Mce And A Pe - H3C S6800 Series Configuration Manual

Step
8. Redistribute remote site
routes advertised by the PE
into BGP.
9. (Optional.) Configure
filtering of advertised routes.
10. (Optional.) Configure
filtering of received routes.
2. Configure a VPN site:
Step
1. Enter system view.
2. Enter BGP view.
3. Configure the MCE as an
IBGP peer.
4. Enter BGP-VPN IPv6 unicast
address family view.
5. Enable BGP to exchange
IPv6 unicast routes with the
peer.
6. Redistribute the IGP routes
of the VPN into BGP.

Configuring routing between an MCE and a PE

MCE-PE routing configuration includes these tasks:
Binding the MCE-PE interfaces to IPv6 VPN instances.
•
Performing routing configurations.
•
• Redistributing IPv6 VPN routes into the routing protocol running between the MCE and the PE.
Perform the following configuration tasks on the MCE. For information about configuring the PE, see the
documentation for the PE.
Configuring IPv6 static routing between an MCE and a PE
Step
1. Enter system view.
Command
import-route protocol
[ process-id [ allow-direct | med
med-value | route-policy
route-policy-name ] * ]
filter-policy { acl6-number |
prefix-list ipv6-prefix-name }
export [ protocol process-id ]
filter-policy { acl6-number |
prefix-list ipv6-prefix-name }
import
Command
system-view
bgp as-number
peer { group-name |
ipv6-address } as-number
as-number
address-family ipv6 [ unicast ]
peer { group-name |
ipv6-address } enable
import-route protocol
[ process-id [ allow-direct | med
med-value | route-policy
route-policy-name ] * ]
Command
system-view
31
Remarks
By default, no routes are
redistributed into BGP.
By default, BGP does not filter
advertised routes.
By default, BGP does not filter
received routes.
Remarks
N/A
N/A
N/A
N/A
By default, BGP does not
exchange IPv6 unicast routes
with any peer.
By default, no routes are
redistributed into BGP.
A VPN site must advertise VPN
network addresses to the
connected MCE.
Remarks
N/A