Table of Contents
Advertisement
Bath/Shower Mixer
1. The hot and cold water outlets should be 150mm
apart (plus or minus 12mm). Hot on the left and
cold on the right (fig. 1). The recommended
plumbing fittings are ½" back plate elbows (not
supplied).
2. Flush through the hot and cold water supplies.
3. Wrap PTFE tape round the S-unions and screw
into the backplate elbows. The S-unions must
protrude beyond the tiled surface between 32
and 41mm (figs.2-3).
4. Seal the gap between the S-unions and the tiles
(fig.3).
5. Screw the escutcheons onto the S-unions.
6. Fasten the mixer onto the S-unions using the
union nuts. Align the unit and tighten the nuts
(be careful not to damage the chrome finish). The
S-unions allow inaccuracies to be compensated
for.
Bath/Shower Mixer with pillar union
Two options
a. As the shower mixer above (positioned over a
bath).
b. Fitting to the bath using the supplied pillar uni-
ons.
1. The pillar unions are designed to fit tap holes
on a bath 180mm apart with hot on the left and
cold on the right (fig.4).
2. Flush through the hot and cold water supplies.
3. Place fibre washers into the holes of the chrome
union nuts. (DO NOT USE FILTERS WHEN
USING PILLAR UNIONS!)
From under the bath fit a large seal washer over
the thread then fix with the nuts.
4. Fasten the mixer onto the union pillars using the
union nuts (be careful not to damage the chrome
finish).
11
Advertisement
Table of Contents
