Advertisement
TECHNICAL DATA
This product is supplied with an integrated
LED module (2800K warm white, 200-300
lumens). The expected lifespan of the LED
module is 25,000 hours, which equates to
8-10 years of general use. When the light
source reaches its end of life, the whole
luminaire should be replaced.
ATTENTION
Ensure that the power supply to the
circuit has clearly been turned OFF
before installing the product. In some
countries, electrical installation must be
carried out by authorised electricians/
contractors; please check with your local
authority for guidance. The product must
not be modified in any way. HAY accepts
no responsibility for any products that
have been modified or tampered with.
The external flexible cable or cord of
this luminaire cannot be replaced. If the
cord is damaged, the luminaire should be
replaced. This lamp is designed for indoor
use only.
NOTE: This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
– CARE AND MAINTENANCE –
guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio
or television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
/ Reorient or relocate the receiving
/ Increase the distance between the
/ Connect the equipment into an outlet
/ Consult the dealer or an experienced
Warning: Changes or modifications to this
unit not expressly approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
CARE AND MAINTENANCE
Do not use wet or damp cloths for cleaning
and maintaining the shade. Please use a
dry, lint-free cloth or duster to remove any
dirt. The frame can be cleaned with a soft
damp cloth and mild detergent, or a dry
microfiber cloth. Do not use alcohol or any
other solvents to clean the product and
avoid using abrasive or rough sponges.
Ensure that the power supply has been
turned OFF before cleaning the product.
antenna.
equipment and receiver.
on a different circuit to the one the
receiver is connected to.
radio/TV technician for help.
Advertisement
