Advertisement
Installing the Trackstaff V3 Pagers
GENERAL INFORMATION
The Trackstaff V3 Pagers are used in conjunction with the Pagertec transmitters. The
message pagers are used as an on-premise paging system to increase efficiency by
alerting customers or staff.
CHARGING BASE INSTALLATION
1. Install the charging base.
2. Charge pagers for 24 hours prior to first use.
Note: Keep rechargeable pagers on charge even during extremely long
periods of inactivity.
WARNING:
Do not connect more than 3 charging bases to a single power supply.
Only use the power supply that came with your charger. Damage caused from
improper electrical connection including but not limited to the incorrect power supply
is not covered under the standard warranty. If you're uncertain about which power
supply to use, contact our customer support department.
Advertisement
