Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for pagertec Matrix Stand Alone
Summary of Contents for pagertec Matrix Stand Alone
- Page 1 Matrix- Stand Alone with BMTX Manual...
-
Page 2: Charger Installation
We recommend some type of surge suppressor on the power supply for protection. Power surges are not covered under system warranty! The Matrix Pagers are used in conjunction with several of the Pagertec transmitters. The guest pagers are used as an on-premise paging system to increase efficiency by alerting customers who are waiting, usually for services or goods. -
Page 3: Operation
2. Record the pager number and hand it to your guest. 3. Page the pager by entering the number into the transmitter. 4. Pagertec Matrix Pagers will flash or vibrate (if enabled) depending on the page mode that is selected. -
Page 4: Setup Menu
SETUP MENU To enter programming mode, press the “SETUP” button on the transmitter and enter the passcode “1357” followed by “Enter”. If the password is accepted, the display will show the first menu option which is Auto Message (Use the “#” & ”*” key to scroll through the different menu options or press “CANCEL”... - Page 5 F requency With this feature, you can have the option of changing your Transmitter Frequency. To change the Frequency of your transmitter follow the below instructions: At the “Frequency” menu press the “ENTER” key You will need to select a Number from 1 – 59 each number has a Frequency associated to it. Type in the number then Press “ENTER”...
-
Page 6: Operating Mode
Operating Mode: This option can change the Operating mode of the Transmitter. Default: Pagertec Power Level: This option allows you to change the power output level. The output level gives different ranges to the transmitter. To Chose an Option Press “Enter” and select desired Output Power by Using the “*”... -
Page 7: Serial Protocol
Range Test: This option allows you to do a range test with the pagers. To use it you will need the capcode the pagers have installed as the range test capcode. Serial Protocol: This option allows the Transmitter to have a serial input to a PC via USB Default:... - Page 8 1. R eorient the receiving antenna. 2. I ncrease the separation between the equipment and receiver. 3. C onnect the equipment into and outlet on a circuit different from that to which the receiver is connected. 4. C onsult the dealer or an experienced radio/TV technician for help. Any special accessories needed for compliance must be specified in the instruction manual.