Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for pagertec TRACKSTAFF V3
Summary of Contents for pagertec TRACKSTAFF V3
- Page 1 TRACKSTAFF V3 PAGING SYSTEM USER GUIDE...
- Page 2 Thank you for choosing Pagertec Thank you for choosing Pagertec as your provider for your wireless paging requirements. We greatly appreciate your confidence in our products. At Pagertec our greatest commitment is providing you with total customer satisfaction. Please take a few minutes to review this manual prior to installing and operating your system.
-
Page 3: Paging System
Track Staff V3 PAGING SYSTEM... - Page 4 TrackStaff V3 Installing the Transmitter The first consideration in the placement of the transmitter is convenience. It should be readily accessible in a central location within the paging area. Pay close attention to nearby obstructions such as walls, pipes, ducts, mirrored glass, or other similar barriers that may weaken or misdirect transmitted signals.
-
Page 5: General Information
GENERAL INFORMATION The TrackStaff V3 Pagers are used in conjunction with the Pagertec transmitters. The staff pagers are used as an on-premise paging system to increase efficiency by alerting staff members to return to the kitchen usually to expedite food. who are waiting, usually for services or goods. -
Page 6: Battery Installation
OPERATION 1. Remove a pager from the charging station. Pagers will light up to signal they have power. 2. Record the name of the staff member next to the pager number. (Use dry erase marker) 3. Press the number on the transmitter of the pager you wish to activate 4. - Page 7 After everything is attached, put the pin back in place and slide in until it locks. Replace clip with an appropriate replacement part available for purchase as an accessory from Pagertec. Metal Clip: To do this first remove the screw holding the clip on to the pager with a small screwdriver.
-
Page 8: System Programming
Pagertec pagers are made from industrial-strength, polycarbonate material. However, this material is susceptible to hairline cracking if non-approved cleaners are used. When cleaning Pagertec pagers, you should only use ETHYL ALCOHOL (ethanol) or ISOPROPYL ALCOHOL-BASED CLEANERS. We have done extensive testing with available cleaning materials and have not found any issues with either ethyl alcohol (ethanol) or isopropyl alcohol (IPA). -
Page 9: Repeat Interval
● Every 5 seconds a beep will go off on the pager to signal the page was received. Once you stop hearing the beeps you will know you are out of range. To exit the testing feature press “Cancel”. If you need more range Pagertec provides signal repeaters to increase range. - Page 10 Use the “▲”“▼” key to scroll through these 6 alert modes. Pagers that have successfully received the change alert mode message will blink all LED lights. At this point, all of the pagers in your system should alert with the alert mode that you selected.
-
Page 11: Mounting On The Wall
7. SET F1-F4 MODE With this feature you will be able to program your transmitter to make calls giving a specific vibration Alert and colored flashing light to signal each pager where they are being called from. ● Options are: F1, F2, F3, F4, OFF This option will be enabled normally if you order more than 1 Server Transmitter in your order. -
Page 12: Fcc Compliance And Advisory Statement
FCC COMPLIANCE AND ADVISORY STATEMENT This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, according to Part 15 of the FCC rules.