General Information - pagertec TRACKSTAFF V3 User Manual

GENERAL INFORMATION

The TrackStaff V3 Pagers are used in conjunction with the Pagertec transmitters. The staff
pagers are used as an on-premise paging system to increase efficiency by alerting staff
members to return to the kitchen usually to expedite food. who are waiting, usually for services
or goods.
CHARGING BASE INSTALLATION
1. Install the charging base.
2. Charge pagers for 24 hours prior to first use.
Note: Keep rechargeable pagers on charge even during extremely long periods of inactivity.
WARNING: Do not connect more than 3 charger base plates to a single power supply. Only
use the power supply that came with your charger. Damage caused from improper electrical
connection including but not limited to the incorrect power supply is not covered under the
standard warranty. If you're uncertain about which power supply to use, contact our customer
support department.
5