Advertisement
Quick Links
Advertisement
Related Manuals for pagertec Simple Alert
Summary of Contents for pagertec Simple Alert
- Page 1 Simple Alert Paging System USER MANUAL...
- Page 2 Thank you for choosing Pagertec Thank you for choosing Pagertec as your provider for your wireless paging requirements. We greatly appreciate your confidence in our products. At Pagertec our greatest commitment is providing you with total customer satisfaction. Please take a few minutes to review this manual prior to installing and operating your system.
- Page 3 SIMPLE ALERT PAGING SYSTEM Installing the Transmitter The first consideration in the placement of the transmitter is convenience. It should be readily accessible in a central location within the paging area. Pay close attention to nearby obstructions such as walls, pipes, ducts, mirrored glass, or other similar barriers that may weaken or misdirect transmitted signals.
-
Page 4: Operating The System
2. Record the pager number and hand it to your guest. 3. Page the pager by entering the number into the transmitter. 4. Pagertec Simple Alert Pagers will flash or vibrate (if enabled) depending on the page mode. Note: Beep modes will still flash and vibrate (if enabled) with no audible beep. - Page 5 SET ALERT MODE You will have the option to program your pagers to do one, two, or all three of the following alerts: Vibrate - Flash - Beep. 1. Turn the pager around and press the MODE button. 2. Press the LEARN button several times until you reach the mode you desire: F (Flash), B (Beep), S (Vibrate).
- Page 6 3. After you are done choosing, press the STOP button to lock your selection. SET ALERT TIME You can set each pager to alert for 15, 30, 45, 60, and 90 seconds. 1. Turn the pager around and press the TIME button. 2.
-
Page 7: Turning Pager Off
TURNING PAGER OFF ● Press the MODE button and STOP button simultaneously. GROUP PAGING ● If you wish to use the group paging option you can set multiple pagers to the same number. To change the number of a pager please use the “Sync a pager to a Transmitter”... - Page 8 SYNCING A PAGER TO A TRANSMITTER If you are expanding your system by adding additional pagers please follow the instructions below to sync your new pagers to your transmitter: 1. Turn the pager around and press the LEARN button and the pager will display “-- -- -- --”...
- Page 9 FCC COMPLIANCE AND ADVISORY STATEMENT This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired Operation.