CyberPower OP650 User Manual page 14

2. The aggregate ceiling amount for all Connected Equipment: CyberPower UP650
--$125,000
3. The amount(s) of all payment you have or are entitled to receive from insurance, other
warranties, extended warranties, or from other sources or persons for the Connected
Equipment or damage to such equipment so that CyberPower's maximum liability shall be
reduced to reflect all such other payments or sources of recovery
If CyberPower replaces the connected equipment or pays to the Initial Customer the Agreed
Damage Amount, the Initial Customer shall transfer all item(s) to CyberPower without
warranty by the Initial Customer, but free of lien or other interest.
CONDITIONS COMMON TO THE LIMITED WARRANTY AND THE POWER CONTROL
GUARANTEE
The Limited Warranty and the Power Control Guarantee are the only and the exclusive
express warranty of CyberPower with respect to the Product. This exclusion of other
express warranties applies to written and oral express warranties.
LIMITATION: THE LIMITED WARRANTY AND THE POWER CONTROL GUARANTEE
DO NOT COVER
The Limited Warranty and the Power Control Guarantee are intended to exclusive rights and
remedies and replace any other rights, to the extent allowed by law.
1. As to the CyberPower Product, the limited warranty does not cover or apply to:
misuse, modification, operation or storage outside environmental limits for the Products,
in transit, in shipment, or in storage, damage or deterioration, improper operation or
maintenance, or use with items or equipment not designed or intended for use with the
product.
2. As to Connected Equipment, the Power Control Guarantee covers only damage within
the specific terms of the Power Control Guarantee to Connected Equipment (and only up
to the applicable aggregate ceiling amount).
3. The Power Control Guarantee does not cover damage to Connected Equipment or
apply if the Product has been operated in a failure mode or not in compliance with
CyberPower operating instructions and manuals, or if the Connected Equipment has
been operated in a failure mode or not in compliance with the instructions and manuals
of its manufacturer/vendor.
The Limited Warranty and the Power Control Guarantee Do Not Apply Unless The
Initial Customer:
1. Has properly connected the Product and the Connected Equipment to properly wired
and grounded outlets (including compliance with electrical and safety codes of the most
current electrical code (ANS/NFPA 70), without the use of any adapters, extension cords
of other connectors.
2. Has provided a suitable and proper environment for use and installation of the Product
and Connected Equipment.
3. Has properly installed and operated the CyberPower Product and Connected
equipment.
4. Has operated the Product at all times within the limitations on the Product's VA
capacity as stated in this User Manual.
CyberPower Does Not Cover or Undertake Any Liability in Any Event for Any of the
Following:
1. Loss of or damage to data, records, or software or the restoration of data or records,
or the reinstallation of software.
2. Damage from causes other than AC Power Line Transients, spikes, or surges on
12