See the Regulatory Notices for all regulatory and safety guidance prior to configuration.
Avant de procéder à la configuration, veuillez consulter les Avis de réglementation, afin de prendre connaissance des recommandations en matière de sécurité et de réglementation.
Get Started
Before you begin, make sure that you have the following:
•
Network preparation (See
Prepare your environment for Microsoft Teams
•
Microsoft Teams Room License (See your Office 365 Admin Center and
•
Account credentials (See
Configure accounts for Microsoft Teams
•
USB keyboard and mouse
•
Display HDMI cable(s)
•
Phillips #1 screwdriver and flathead screwdriver
•
(Optional) EDID emulator (see step 7)
Unpack the Poly Studio, Poly GC8, Conferencing PC, 10 m USB-A to USB-C cable, and mounting kit (if applicable) from their boxes.
Note: To avoid changes to the video configuration, do not use the Poly Studio remote control.
Page 1
(Optional) EDID emulator (see step 7) Unpack the Poly Studio, Poly GC8, Conferencing PC, 10 m USB-A to USB-C cable, and mounting kit (if applicable) from their boxes. Note: To avoid changes to the video configuration, do not use the Poly Studio remote control.
Page 2
10. Connect the keyboard and mouse to the Conferencing PC. Phillips #1 screwdriver, turn the GC8 faceup, press the rubber circles on 11. Plug in and power on the Poly GC8 and then plug in and power on the other each side, and slide the panel off.
Page 3
This product cannot be connected directly to the telecommunications circuits (or public wireless LANs) of any telecommunication carriers (e.g., mobile communications carriers, fixed communications carriers, or internet providers). In the case of connecting this product to the Internet, be sure to connect it via a router.
Need help?
Do you have a question about the G40-T and is the answer not in the manual?
Questions and answers