Standby Screen Overview - KELVIN HUGHES HBK-4002 Quick Start Manual

4.2 Standby screen overview

Each section of the standby screen is briefly detailed below.
Note: Some functions are only available when they have been enabled in Optional Features.
If the graphic for a function is greyed out and cannot be selected, it has not been enabled.
4.2.1 Go to Run ...
TRANSMISSION WARNING: When a transceiver is set as Master, selecting radar, ECDIS
or navigation and conning display modes will cause the selected transmitter to transmit and
antenna to rotate.
Kelvin Hughes
MANTADIGITAL
4 Getting started
Chapter :
Place the cursor over the desired mode and left click to set
to run (see warning below).
Single Radar Display: Sets the selected transmitter to run and
starts Single Radar Display mode with a single PPI.
Dual Radar Display: Sets the selected transmitter to run and
starts Dual Radar Display mode with a primary and secondary
PPI.
Conning Display: Starts Conning Display mode.
Navigation and Conning Display: Sets the selected
transmitter to run and starts Navigation and Conning Display
mode.
ECDIS: Starts ECDIS mode.
HBK-4002, issue 2 February 2013
Page 6 of 26
TM
Quick Start Guide: